With the rapid development of the times, China's industrial level is getting higher and higher now. Under such circumstances, people's lives have also undergone tremendous changes. This mainly depends on the development of China's industrial technology and technology. For example, when many products are produced, mass production can be carried out through moulds. However, in order to ensure the quality of those products, there are more stringent requirements on all aspects of mould production. What standards and conditions must be met when producing such moulds? The following is to tell you the standards and conditions for the production of Dustbin Mould.
First, stiffness and hardness.
Perhaps some people think that when using various standards and conditions to produce plastic products because the hardness and height of plastic products are not particularly large, and more importantly, they do not need to be squeezed with too much force during the production process, so there is no need to have very high requirements on the rigidity and hardness during the production standards and conditions, which will only increase the cost in vain and will not bring any useful value to the production. However, this idea is not correct, because, in the process of using these standards and conditions, various problems such as bumping or squeezing will inevitably occur. If the rigidity and hardness do not meet the standards, its service life will be seriously affected at this time, which is likely to lead to obvious fracture problems in the process of use, thus there is no way to continue to use.
Second, the smoothness of the surface.
If you have ever used standards and conditions to produce various products, you should know that most of the products produced have very smooth surfaces, because such products only look cleaner and have higher quality. Therefore, in order to ensure that these standards and conditions can make the surface of these products smoother during the production of moulds, the moulds themselves must have certain smoothness. Only in this way can the surface of the manufactured product be effectively prevented from having potholes or various problems, and more importantly, only when the surface becomes smoother can the product be taken out more easily, thus effectively improving the production efficiency.
Third, there must be a strong wear resistance.
Some people think that when using the standards and conditions to produce various products, they generally do not need to go through serious friction, so the friction requirements for the mould are not particularly strict, but in fact, there will still be some friction in the production process. After all, this mould is not a disposable product and tool, and it is used many times every day, so in this case, as long as there is a little friction each time. As time goes by, there will be accumulated effects. Then the final mould will definitely have various problems such as obvious deformation or size consumption. Therefore, in the process of mould production, you also need to effectively reduce friction through various design methods, and at the same time, you must also make it achieve higher wear resistance.
If the standards and conditions of production can be followed in production and design, then generally good results can be achieved in the end, and in the future, you can ensure that all kinds of moulds you order can achieve such effects. At this time, you must choose a large company such as Xubang to order, after all, their requirements for production are still relatively strict.
